Can you hook up subs to stock radio

can you hook up subs to stock radio

How to connect a subwoofer to a car stereo?

Get the remote wire in your wiring kit. Once you splice it, solder this wire to the remote wire of your stock stereo. After this is done, run the remote wire through the dashboard and the door jam. While the stereo is out, plug in the RCA red and white plugs into the Subwoofer Output, which can be found at backside of the deck.

Can I use my stock radio with a line level subwoofer?

Regardless of whether you choose to go with a self powered line level subwoofer or with a custom enclosure powered by an external amplifier (w/line level inputs) you can still use your stock (OEM) radio.

Where to tap into speaker wire for subwoofer?

Generally if tapping into factory wires for a subwoofer, its best to tap into the rear speaker leads. This mainly comes into play if an aftermarket radio is installed and a high pass filter is set on the front speakers to eliminate some of the bass from the front of the vehicle and of course this would take those lower frequencies away from ...

How do you hook up speakers to the radio?

We grounded to a seat bolt right here back by the amplifier, and then we grabbed speaker wire signal from the factory radio in the dash, connected that to a line output converter right behind the radio, and ran RCA cables and our blue remote turn on wire from behind the radio, down the drivers side of the vehicle, right back here to our amplifier.

How to install a subwoofer in a car?

Remove the fuse and connect the subwoofer with the main power supply to start with the installation process. Disconnect the speaker from in-built car speaker by doing mounting dock and gaining access on the rear panel of the car stereo by using wiring. After that, take out the stereo wiring and reconnect it again by using an adapter.

Should you disconnect the car battery to connect a subwoofer?

By disconnecting the car battery, you can prevent it from losing voltage while you attempt to connect a subwoofer to the car’s stereo. In most cases, a car’s fuse box is in between the stereo and power supply.

Can I wire my rear speakers as subwoofers?

By wiring rear speaker output as a subwoofer output, you will not get a shattering bass, but it will add extra frequency to your sound system.

Do you need a subwoofer speaker crossover for a car?

The point is that unless you want to hear vocals and other sounds from the car subwoofer, you’ll need to hook up a subwoofer speaker crossover between the stereo & the sub. For clear bass, you’ll need a crossover to block higher-frequency sounds subs can’t play well.

How do you hook up speaker wire to receiver?

In most cases, a home stereo receiver or amplifier allows connecting speaker wire using the binding posts and/or banana plug jacks. You can usually connect speaker wire to an amplifier or receiver pretty easily. Here’s how: Loosen the binding post twist tops enough to expose the wire hole.

How do I connect my speakers to my computer?

If your speakers require a power source to amplify the audio, there should also be a power cord. This cord needs to connect to a wall outlet or surge protector outlet. In the back of the computer, connect the mini plug to the audio line-level output. This port is usually colored lime green, as in the picture at right.

How to connect a Bluetooth speaker to your phone?

One end connects to the speaker and one to the smartphone. For Bluetooth connection, you can pair your devices with your phone. Once you connect with the Bluetooth speaker, open the FM radio or Internet radio app on your smartphone, then simply play your favorite radio station. Following you will find the process which I explain above.

How do you connect an amplifier to a receiver?

Connecting Receivers or Amplifiers . Wires must be connected correctly on both the receiver or amplifier and speakers. The positive speaker terminal (red) on the receiver or amplifier must be connected to the positive terminal on the speakers, and the same applies to the negative terminals on all the equipment.

Related posts: